Cisco ATA 186 구성 매뉴얼 - 페이지 4

{카테고리_이름} Cisco ATA 186에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ATA 186 8 페이지. Analog telephone adaptor
Cisco ATA 186에 대해서도 마찬가지입니다: 구성 (28 페이지), 데이터시트 (7 페이지), 개요 (11 페이지), 개요 매뉴얼 (11 페이지), 사용자 설명서 (12 페이지), 설치 및 구성 매뉴얼 (13 페이지), 설치 지침 (6 페이지), 구성 (6 페이지)

페이지 인쇄

ATA

ONFIGURE THE

To configure your ATA to use DHCP:

1. Pick up the handset of the phone connected to the ATA, and then press the button on top of the

ATA. The system announces, "Configuration Menu. Enter menu number followed by the # key..."

2. Press 20# on the phone's keypad to access the DHCP menu. The system announces, "Enter value."

3. Press 1# to enable DHCP. The system announces, "You entered '1.' To change, press 1; to review,

press 2; to save, press 3; to review your saved value, press 4; or press the pound key (#) to exit."

4. Press 3 on the phone's keypad to save the settings. The system announces, "Value saved.

Configuration Menu..."

5. Place the phone's handset back on the phone to hang up. The light on top of the device will flash red

for a second.

Note: If the ATA continues to flash the red light for more than two minutes, it is not connected to a DHCP server.

Configure the ATA with a static IP address instead. Refer to the Static IP Configuration section on page 2.

6. To confirm the IP address assigned to the ATA, pick up the handset of the phone connected to the

ATA, and then press the button on top of the ATA. The system announces, "Configuration Menu.

Enter menu number followed by the # key..."

7. Press 80# on the phone's keypad to hear the IP address. When the system announces the ATA's IP

address, write it down.

Note: If the system announces the IP address as "0.0.0.0,"there could be two possible causes. The first possibility is

that the network to which the ATA is connected does not have a DHCP server. If this is the case, skip to the

Static IP Configuration section on page 2. The second possibility is that the DHCP server has been unable to

assign an IP address to the ATA. If that is the case, notify your network administrator of the problem.

8. Place the phone's handset back on the phone to hang up. To continue configuring the ATA for

CafeFone, skip to the Configuring Account and Network Settings section on page 4.

ATA

ONFIGURE THE

To configure the ATA with a static IP address:

1. Contact your Internet Service Provider (ISP) or IT Administrator, and obtain the following

information:

IP address

Default Gateway address

Subnet Mask address

Primary DNS Server address

Secondary DNS Server address (optional)

CafeFone Configuration Guide for the Cisco ATA186

DHCP

Note: To repeat the IP address announcement, press 80# again.

IP A

TATIC

Page 2

DDRESSING