Cisco IC3000 하드웨어 설치 매뉴얼 - 페이지 25

{카테고리_이름} Cisco IC3000에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco IC3000 37 페이지. Industrial compute gateway
Cisco IC3000에 대해서도 마찬가지입니다: 제품 문서 (12 페이지)

페이지 인쇄

1. Initial Configuration

Connecting the Cisco IC3000

This chapter describes how to connect the Cisco IC3000 to Ethernet devices and a network.

•

Connecting the Cisco IC3000 Industrial Compute Gateway

This chapter describes how to connect the Cisco IC3000 to Ethernet devices and a network. The chapter

contains the following sections:

Preparing to Connect the Cisco IC3000

Before you connect the Cisco IC3000 to the devices, install the IC3000 according to the instructions in

Installing the Cisco IC3000 Industrial Compute Gateway, on page

Caution: If this product will be installed in a hazardous location, read the Getting Started/Product Document

of Compliance included in the package.

WARNING: To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to

telephone-network voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV

circuits. Some LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables. Statement

1021

Preventing Damage to the Cisco IC3000

Before installation, observe these general guidelines:

• Proper ESD protection should be observed

• Ensure the device is properly grounded

• Ensure there is proper airflow around the device

Connecting a PC to the Cisco IC3000 For Configuration

There are two methods of connecting to the Cisco IC3000 in case of troubleshooting:

Connect a PC to the console connector of the Cisco IC3000 and launch a console terminal to use the CLI.

Connect the PC to the Cisco IC3000 management sub-network which will then receive an IP address.

Connecting the Cisco IC3000 Industrial Compute Gateway, on page 23

C H A P T E R

Cisco IC3000 Industrial Compute Gateway Hardware Installation Guide

17.