AER Lily one 설치 매뉴얼 - 페이지 3
{카테고리_이름} AER Lily one에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AER Lily one 12 페이지. Twin source rechargeable pick up system for acoustic instruments
AER Lily one에 대해서도 마찬가지입니다: 빠른 시작 (3 페이지)
페이지 인쇄Checklist
Check the contents of the package to make
sure everything is complete:
1 x Lily one piezo pick-up with 2.5 mm jack
•
1 x Lily one endpin preamp with integrated
•
microphone, soundhole control (SHC)
with installed battery
•
1 x adhesive tape for SHC
•
3 x cable clamps
•
Manual/Instruction guide
•
1,5 m USB-Jack charging cable
1. General requirements
•
Check the string spacing, centre to centre
of the string, or middle between a pair, to
make sure it matches Lily one.
•
Make sure that the saddle has a minimum
width of 2,3 mm. The undersaddle pickup
is 2,3 mm wide.
•
Check the string pressure on the pickup
crystal by assuring a minimum 20° break
angle, if more all the better. If your instrument
does not provide this, the string slots
will need ramping (done by a luthier).
•
Fitting the Lily one soundhole control (SHC)
•
Check the inside of the guitar to identify
the ideal position for the Lily one SHC on the
bass side of the soundhole for easy operation
while performing.
•
Bracing around the soundhole differs
between makers and can conflict with the
control unit. Some guitar constructions requi-
re an underlay to glue the SHC on properly. In
any case should the gluing surface be flat and
free of dust or grease.