Xerox WORKCENTRE 7435 보충 설명서 - 페이지 18
{카테고리_이름} Xerox WORKCENTRE 7435에 대한 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox WORKCENTRE 7435 49 페이지. Security function
Xerox WORKCENTRE 7435에 대해서도 마찬가지입니다: 참조 매뉴얼 (28 페이지), 브로셔 및 사양 (8 페이지), 사양 (15 페이지), 평가자 매뉴얼 (32 페이지), 사양 (14 페이지), 소프트웨어 업그레이드 (2 페이지), 빠른 시작 매뉴얼 (7 페이지)
페이지 인쇄
Set SNMPv3
1.
Click [+] on the left of the [Connectivity] folder on the [Properties] screen.
2.
Click [+] on the left of the [Protocols] folder.
3.
Click [SNMP Configuration].
4.
Check the [Enable SNMPv3 Protocol] box.
5.
Uncheck the [Enable SNMP v1/v2c Protocols] box.
6.
Click the [Apply] button.
7.
Click the [Edit SNMPv3 Properties] button and check the [Account Enabled] for [Administrator Account].
8.
Enter a new Authentication Password (minimum 8 characters).
9.
Enter the Confirm Authentication Password.
10. Enter a new Privacy Password (minimum 8 characters).
11. Enter the Confirm Privacy Password.
12. Check the [Account Enabled] for [Print Drivers/Remote Clients Account].
13. Click the [Apply] button.
Note:
Authentication Password and Privacy Password have to be changed certainly from default Password.
•
In using SNMPv3, use the IPSec protocol simultaneously. Therefore the IP address of the client for SNMPv3
•
have to be set according to the procedures "Set IPSec Address" (3.5).
Enter the IP Address in the [Specify Destination IPv4 Address] box.
Since the machine cannot communicate by SNMP v1/v2, the port setting on the client Print Driver have to be
•
select [LPR] for [Protocol], and uncheck the [SNMP status Enabled].
18