Xerox Synergix 8855 보충 설명서 - 페이지 23
{카테고리_이름} Xerox Synergix 8855에 대한 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Synergix 8855 28 페이지. Windows nt 4.0 postscript print driver user guide
Xerox Synergix 8855에 대해서도 마찬가지입니다: 사용자 설명서 (44 페이지), 운영자 매뉴얼 (11 페이지), 보충 설명서 (26 페이지), 소프트웨어 설명서 (30 페이지)
페이지 인쇄
Preparing the Host SCSI Port
Ultra SCSI Port (Host)
To use this port your workstation must have a SCSI interface card and
appropriate software installed and operating.
Enable Controller SCSI Port
Use the Printer_Defaults>Ports menu of the Web PMT to set a device
number compatible with your workstation and to disable the termination. By
default, the host SCSI port bus termination is enabled.
Figure 6 – Typical Web PMT, Ports Setup Page
XES Synergix 8855 Controller Setup Manual for Firmware 7.0
Software Supported
•
ServeWare Version 2.42 or later.
•
VGS (in Xerox 150 Emulation Mode)
Data Formats Supported
•
Xerox 150 Emulation
•
Versatec Raw Raster
•
VDS
•
VCGL
SCSI Cable Description
The SCSI cable must not exceed a maximum length of 9.75 feet (3 meters).
15