Clarke CCO14B 운영 및 유지보수 지침 매뉴얼 - 페이지 11
{카테고리_이름} Clarke CCO14B에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CCO14B 17 페이지. Abrasive cut-off saw
페이지 인쇄CHANGING THE CARBON BRUSHES
Maintenance to the motor is limited to changing
the carbon brushes.
These will naturally wear with use and require
replacing. They should be checked periodically as
follows:
1. Unscrew and remove the plastic covers on the
end of the motor with a screwdriver.
2. Pull out the brushes complete with springs and
retainers.
3. Check the brush length, if the 'wear line'
cannot be seen ('A' fig.8), the pair should be
renewed.
4. Replace the brushes, taking care to ensure that
the tabs on the end of the spring retainer ('B'
fig.8), correctly enter the elongated chamber as you push it in and screw
on the cap.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
11