Cub Cadet 221 HP 운영자 매뉴얼 - 페이지 10

{카테고리_이름} Cub Cadet 221 HP에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cub Cadet 221 HP 20 페이지. Single stage snow thrower
Cub Cadet 221 HP에 대해서도 마찬가지입니다: 브로셔 및 사양 (2 페이지), 사양 (2 페이지), 운영자 매뉴얼 (20 페이지)

페이지 인쇄

Operation

NOTE: Refer to the Engine Operator's Manual for instruction on

starting, stopping and operating the engine.

Engaging the Auger

To engage the auger and start throwing snow, squeeze the

auger control against the handle. Release to stop the auger.

See Fig. 5-1.

Auger

Control

Handle

Engaging the Drive

Lift up slightly on the handle to allow the rubber paddles on the

auger to contact the pavement and propel the snow thrower

forward. Pushing downward on the handle will raise the auger

off the ground and stop the forward motion.

NOTE: Excessive upward pressure on the handle will result

in premature wear on the rubber auger blades which will

not be covered by the warranty.

Clearing a Clogged Discharge Chute

WARNING!

clogged chute assembly. Shut off engine and remain

behind handles until all moving parts have stopped

before using the clean-out tool to clear the chute

assembly.

Hand contact with the rotating impeller inside the discharge

chute is the most common cause of injury associated with snow

throwers. Never use your hand to clean out the discharge chute.

To clear the chute:

SHUT THE ENGINE OFF!

Wait 10 seconds to be sure the impeller blades have

stopped rotating.

Always use a clean-out tool, not your hands.

Figure 5-1

Never use your hands to clear a

Chute

Refer to Fig. 5-2 for the chute controls.

Chute Control

Handle

Upper

Chute

Figure 5-2

To increase the angle/distance snow is thrown, pull up/back on

the upper chute. To decrease the angle/distance snow is thrown,

push down/forward on the upper chute.

To rotate the chute to the left, turn the chute control handle to

the right. To rotate the chute to the right, turn the chute control

handle to the left.

Wing Nut