Aluprof ER-P Series 프로그래밍 매뉴얼 - 페이지 6

{카테고리_이름} Aluprof ER-P Series에 대한 프로그래밍 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aluprof ER-P Series 8 페이지.
Aluprof ER-P Series에 대해서도 마찬가지입니다: 프로그래밍 매뉴얼 (9 페이지)

페이지 인쇄
Aluprof ER-P Series 프로그래밍 매뉴얼
8. ERASING THE LIMIT POSITIONS
The MOTOR can't be in the limit positions during reset.
Press the „P2" button and hold it
for 7 seconds.
9. ERASING ONE TRANSMITTER.
Switch to programming mode
according to point 4.
10. PROGRAMMING THE DIRECTION OF MOVEMENT
Switch to programming mode
according to point 4.
11. ACTIVATION OF THE IMPULSE MODE
Switch to programming mode
according to point 4.
6
PROGRAMMING MANUAL FOR AM45 MOTORS ER-P SERIES
After 1 second the motor will
make a short move DOWN - UP.
Press the „P2" butto and hold for
1 second.
Press the „DOWN" button.
Press the „STOP" button.
After 7 seconds the motor will
make two short moves DOWN - UP.
The motor will make a short
move DOWN - UP.
The motor will make a short
move DOWN - UP.
The motor will make a short
move DOWN - UP.
The limit positions
have been deleted.
The transmitter has been
deleted.
The setting has been saved.
The setting has been saved.
We reserve the right to any technical change.
Valid on 2022.01.27