Aluprof DC 448 프로그래밍 매뉴얼 - 페이지 3

{카테고리_이름} Aluprof DC 448에 대한 프로그래밍 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aluprof DC 448 4 페이지.
Aluprof DC 448에 대해서도 마찬가지입니다: 프로그래밍 매뉴얼 (4 페이지)

페이지 인쇄
Aluprof DC 448 프로그래밍 매뉴얼
DC 448 PROGRAMMING MANUAL
2.2. Setting of the timer
Programming of the timer can be performed only in 'MAN' mode.
If there will be a bigger interval during the programming than 10 seconds the timer will go from the setting mode out.
Hold the „SET P2" button for 2 second will
Hold the „MODE/K-" button for 5 seconds
The operation of the „UP" and „DOWN"
With the help of the „OK / K +" - button
switch the transmitter to the 'MAN' mode.
keys changes the hour settings
till the hour will blink
we confirm all changes
The operation of the „UP" and „DOWN"
Press the „MODE/K-" to confirm
The operation of the „UP" and „DOWN"
With the help of the „OK / K +"
keys changes the minute settings
keys changes the day of the
- button we confirm all changes
the minute.
week settings
We reserve the right to any technical change. Valid on 2019.03.13
3