ASGCO CHEVRON 설치, 운영 및 유지보수 지침 매뉴얼 - 페이지 8

{카테고리_이름} ASGCO CHEVRON에 대한 설치, 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ASGCO CHEVRON 12 페이지. Belt cleaners

Vibro Band and

Bearing Cover

Installation

ASGCO Mfg., Inc.

Before installing the remaining Chevron shafts, the Vibro Band must be

located and installed on this shaft. Proceed as follows:

1. Position a Vibro Band mounting bracket on each side of the chute wall.

The bracket should be located with its top edge approximately 1" below

the belt and perpendicular to the ground (not the belt). The notched

end of the bracket should face up toward the belt and the center of the

chute.

IMPORTANT: There should be a 2" distance between the Vibro Band

mounting bracket and Chevron discs.

Chute Wall

Vibro Band

2. Weld the Vibro Band mounting brackets into position.

3. Take one of the Vibro Bands and hold it up to but not touching the belt

while resting it against the front of the brackets. From the back, mark

the two slot locations on the plastic. Drill a ½" diameter hole at the

bottom of the slot location on each side.

4. Install the Vibro Band on the side of the mounting bracket facing the

head pulley with two 3/8" X I" long bolts and hardware. Adjust it so that

it just kisses the belt across the full width.

CAUTION: The Vibro Bands do not provide cleaning action; their function

is to direct the scraped material away from the next Chevron

and direct it down into the chute. Adjusting the Vibro Bands too

tightly will cause premature wear.

Vibro Band

Mounting Bracket

CHEVRON