ASGCO CHEVRON 설치, 운영 및 유지보수 지침 매뉴얼 - 페이지 9

{카테고리_이름} ASGCO CHEVRON에 대한 설치, 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ASGCO CHEVRON 12 페이지. Belt cleaners

ASGCO Mfg., Inc.

5. The next measurement also varies, depending on the outside diameter

of the Chevron shaft:

A. IF THE OUTSIDE DIAMETER OF THE SHAFT IS 1 ", use a

soapstone and straightedge to scribe a vertical line 1½" up from

each of the "X" end points. Mark each of these end points "N'.

B. IF THE OUTSIDE, DIAMETER OF THE SHAFT IS 1½", use a

soapstone and straightedge to scribe a vertical line 1¾" up from

each of the "X" end points. Mark each of these end points "A".

6. Scribe a horizontal line 21/2" long, with its center intersecting point "A"

on both chute walls. Mark the end points of these lines "Al" and "A2".

7. Scribe vertical lines from points "Al" and "A2" to the top of each chute

wall.

8. Repeat this marking procedure on the remaining "X" points on both

chute walls.

9. Burn or drill a 1diameter hole at each of the "X" points on both chute

walls.

10. Burn or cut along the horizontal and vertical lines scribed in Steps 6-8.

Remove the chute wall material; the result will be rectangular cutouts

above each 1 diameter hole.

11. Insert a ¾" x 2" long bolt into each of the 1" diameter holes. Be sure to

insert the bolts from the inside of the chute walls. Place a flat washer,

lock washer, and nut on each bolt. Only hand tighten the nuts at this

time.

12. Tack weld the heads of each of the bolts on the inside of the chute walls.

6" Disc 1" Bearing

6½"

2½"

1½"

"X"

8" Disc 1" Bearing

BELT

2½"

1½"

"X"

8" Disc 1-3/8" or

1½" Bearing

2½"

1¾"

"X"

10" Disc 1-3/8" or

1½" Bearing

2½"

"X"

CHEVRON