Drummond MTL10 Instruction Manual

Browse online or download pdf Instruction Manual for Test Equipment Drummond MTL10. Drummond MTL10 5 pages. Test lamps
Also for Drummond MTL10: Instruction Manual (5 pages), Instruction Manual (20 pages), Instruction Manual (5 pages)

Print Page
Drummond MTL10 Instruction Manual
MTL10 & MTL20
1 SAFETY INFORMATION
REMEMBER: SAFETY IS NO ACCIDENT
These instructions contain both information and warnings that are
necessary for the safe operation and maintenance of this product. It
is recommended that you read the instructions carefully and ensure
that the contents are fully understood. Failure to understand and
to comply with the warnings and instructions can result in serious
injury, damage or even death.
Particular attention should be paid to the Warnings, Precautions and
Technical Specifi cations.
Please keep these instructions for future reference.
Updated instructions and product information are available at:
www.martindale-electric.co.uk
1.1 Meaning of Symbols and Markings
Caution - risk of danger & refer to instructions
Caution - risk of electric shock
Equipment protected by double or reinforced
insulation (Class II)
Suitable for live working
Alternating current (AC)
Direct current (DC)
ON/OFF (push button)
TEST LAMPS
Instruction
Manual
05/12/2013 11:31:05
ALWAYS READ THESE INSTRUCTIONS BEFORE PROCEEDING
Thank you for buying one of our products. For safety and full
understanding of its benefi ts please read this manual before use.
Technical support is available from 01923 441717 and support@
martindale-electric.co.uk.
CONTENTS
1
Safety Information
1.1 Meaning of Symbols and Markings
1.2 Precautions
2
Introduction
2.1 Inspection
2.2 Description
2.3 Accessories
3
Operation
3.1 Control Elements and Connections
3.2 Description of LED Indicators
3.3 Operating Duty Ratio
3.4 Proving Check
3.5 Testing for the Presence of Hazardous Live Voltage
3.6 Push Button Switches (MTL20 only)
3.7 Interference (Phantom) Voltage
4
Maintenance
4.1 Probe Replacement
4.2 Periodic Testing
4.3 Cleaning
4.4 Repair and Service
4.5 Storage Conditions
5
Warranty
Measurement Categories
Specifi cations
MTL10 MTL20 instructions rev8.indd 3
CAT III
(Measurement Category III) is applicable to test and
measuring equipment connected to the distribution part of
the building's low-voltage MAINS installation.
CAT IV
(Measurement Category IV) is applicable to test and
measuring equipment connected at the source of the
building's low-voltage MAINS installation.
Equipment complies with relevant EU Directives
End of life disposal of this equipment should be in
accordance with relevant EU Directives
For further information on measurement categories refer to page 15.
1
2
1
1
3
5
5
5
5
6
6
6
7
7
8
9
9
11
11
11
11
12
12
13
15
05/12/2013 11:31:05