HP StorageWorks 2/32 - SAN Switch Release Note - Page 10

Browse online or download pdf Release Note for Switch HP StorageWorks 2/32 - SAN Switch. HP StorageWorks 2/32 - SAN Switch 32 pages. Fabric manager version 3.0.x release notes
Also for HP StorageWorks 2/32 - SAN Switch: Installation Instructions Manual (20 pages), User Manual (22 pages), Firmware Release Notes (14 pages), Release Note (48 pages), Installation Instructions Manual (6 pages), Release Note (14 pages), Release Note (4 pages)

Print Page

SAN Switch 2/32 Firmware Version 4.0.2b Updates

Fabric OS Command Changes

The following lists new or modified commands added to the Fabric OS Version 4.0.2b:

•

killtelnet command

•

loopporttest command

•

portcfgdelayflogi command

•

supportshow command

•

portcfglongdistance command

•

portcfgshow command

•

ifmodeset command

NOTE: For more information about these commands, refer to the hp StorageWorks Fabric OS

Version 3.0.x/4.0.x Reference Manual.

portcfglongdistance Command Summary

Extended links in the same SAN are either 1Gb or 2Gb, but not both. If you have 1 Gb

extended links in the the SAN you can not add a 2Gb Extended Link to the same SAN.

Enhancement

A new parameter was added to this command. The new syntax is as follows:

portCfgLongDistance [slot/]port[, distance_level][, linkinitmode]

linkinitmode Operand

The linlinitmode operand applies to long distance setup only. It does not affect a

normal link. It is added to ensure the long distance link initialization sequence.

It is not required for long distance, but may be useful when initiating L1 and L2 links.

linkinitmode Usage

Specify 1 to activate a long distance link initialization sequence. Specify 0 to

deactivate this mode. The default value is 0 (disabled). This operand is optional. The

following example is for a 100km link on a port in a V4.0 switch with long distance

link initialization protocol enabled:

switch:admin> portCfgLongDistance 2/3 L2 1

done.

SAN switch 2/32, version 4.0.2b release notes