HP StorageWorks 2/32 - SAN Switch 릴리스 노트 - 페이지 10
{카테고리_이름} HP StorageWorks 2/32 - SAN Switch에 대한 릴리스 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. HP StorageWorks 2/32 - SAN Switch 32 페이지. Fabric manager version 3.0.x release notes
HP StorageWorks 2/32 - SAN Switch에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (20 페이지), 사용자 설명서 (22 페이지), 펌웨어 릴리스 노트 (14 페이지), 릴리스 노트 (48 페이지), 설치 지침 매뉴얼 (6 페이지), 릴리스 노트 (14 페이지), 릴리스 노트 (4 페이지)
페이지 인쇄
SAN Switch 2/32 Firmware Version 4.0.2b Updates
Fabric OS Command Changes
The following lists new or modified commands added to the Fabric OS Version 4.0.2b:
•
killtelnet command
•
loopporttest command
•
portcfgdelayflogi command
•
supportshow command
•
portcfglongdistance command
•
portcfgshow command
•
ifmodeset command
NOTE: For more information about these commands, refer to the hp StorageWorks Fabric OS
Version 3.0.x/4.0.x Reference Manual.
portcfglongdistance Command Summary
Extended links in the same SAN are either 1Gb or 2Gb, but not both. If you have 1 Gb
extended links in the the SAN you can not add a 2Gb Extended Link to the same SAN.
Enhancement
A new parameter was added to this command. The new syntax is as follows:
portCfgLongDistance [slot/]port[, distance_level][, linkinitmode]
linkinitmode Operand
The linlinitmode operand applies to long distance setup only. It does not affect a
normal link. It is added to ensure the long distance link initialization sequence.
It is not required for long distance, but may be useful when initiating L1 and L2 links.
linkinitmode Usage
Specify 1 to activate a long distance link initialization sequence. Specify 0 to
deactivate this mode. The default value is 0 (disabled). This operand is optional. The
following example is for a 100km link on a port in a V4.0 switch with long distance
link initialization protocol enabled:
switch:admin> portCfgLongDistance 2/3 L2 1
done.
10
SAN switch 2/32, version 4.0.2b release notes