FIBARO FGPB-101 Operating Manual - Page 3
Browse online or download pdf Operating Manual for Controller FIBARO FGPB-101. FIBARO FGPB-101 8 pages. Fibaro button
Also for FIBARO FGPB-101: Operating Manual (15 pages), Instructions Manual (6 pages), Operating Manual (15 pages)
Print Page
4
#1: Description and features
FIBARO Button is a compact, battery-powered, Z-Wave Plus
compatible device. It allows you to control devices through the
Z-Wave network and run various scenes defined in FIBARO System.
Different actions may be triggered with one to five clicks or by holding
the button down. In panic mode, each press of the button results in
triggering the FIBARO Alarm.
With its small design and wireless communication, the FIBARO Button
can be conveniently mounted on any surface and in any position or
location at home, e.g. beside the bed or under the desk.
Main features of FIBARO Button:
i
NOTE
•
Compatible with any Z-Wave or Z-Wave+ Controller,
This device may be
•
Supports Z-Wave network Security Mode with AES-128 encryption,
used
with
all
de-
vices certified with
•
Completely
wireless
the Z-Wave Plus cer-
communication,
tificate and should be
compatible with such
•
May be installed anywhere in your home,
devices produced by
•
Extremely easy installation - simply add and put on desired surface,
other manufacturers.
•
Many colour variations: black, white, red, green, blue, yellow,
orange and brown.
i
NOTE
Z-Wave
Controller
must support Z-Wave
Security
Mode
in
order to fully utilize the
product.
DESCRIPTIOn AnD FEATuRES
with
battery
power
and
Z-Wave
FIBARO
Button
is
a
fully
compatible Z-Wave PLUS device.
#2: Basic activation
1. Press and turn the button counter-clockwise to open the casing.
2. Remove the paper strip underneath the battery.
3. Press and turn the button clockwise to close the casing.
4. Place the device within the direct range of your Z-Wave controller.
5. Set the main controller in (security/non-security) add mode (see
the controller's manual).
6. Click the button 6 times at least.
7. Wait for the device to be added into the system, successful adding
will be confirmed by the controller.
8. Install the device in desired location using the attached
self-adhesive pad.
9. Click the button 4 times to wake it up.
5
BASIC ACTIvATIOn