FIBARO FGPB-101 Operating Manual - Page 4

Browse online or download pdf Operating Manual for Controller FIBARO FGPB-101. FIBARO FGPB-101 8 pages. Fibaro button
Also for FIBARO FGPB-101: Operating Manual (15 pages), Instructions Manual (6 pages), Operating Manual (15 pages)

Print Page

#3: Adding/removing the device

Adding (Inclusion) - Z-Wave device learning mode, allowing to add

NOTE

the device to existing Z-Wave network.

Adding

Security

To add the device to the Z-Wave network:

Mode must be per-

formed up to 2 meters

1. Place the Button within the direct range of your Z-Wave controller.

from the controller.

2. Set the main controller in (Security/non-Security) add mode (see

the controller's manual).

NOTE

3. Click the Button at least six times.

4. Wait for the adding process to end.

In case the device is

not added, repeat the

5. Successful adding will be confirmed by the Z-Wave controller's

adding procedure.

message.

Removing (Exclusion) - Z-Wave device learning mode, allowing to

NOTE

remove the device from existing Z-Wave network.

Removing the Button

To remove the device to the Z-Wave network:

from the Z-Wave net-

work restores all the

1. Place the Button within the direct range of your Z-Wave controller.

default parameters of

2. Set the main controller in remove mode (see the controller's

the device.

manual).

3. Click the Button at least six times.

4. Wait for the removing process to end.

5. Successful removing will be confirmed by the Z-Wave controller's

message.

ADDInG/REMOvInG ThE DEvICE

#4: Operating the device

Operating the Button:

1 click:

send action to associated devices (switch on/off by de-

fault) and/or trigger a scene

2 clicks:

send action to associated devices (switch on maximum

level by default) and/or trigger a scene

3 clicks:

send action to associated devices (no action by default)

and/or trigger a scene

4 clicks:

wake the device up and/or trigger a scene

5 clicks:

start reset procedure (press and hold for 5s to confirm)

and/or trigger a scene

6 or more

learning mode (adding/removing)

clicks:

Hold:

send action to associated devices (start level change up/

down) and/or trigger a scene

Release:

send action to associated devices (stop level change)

and/or trigger a scene

Waking up the device:

The Button needs to be woken up to receive information about the

new configuration from the controller, like parameters and associa-

tions.

Click the Button 4 times to wake it up.

Scene ID:

Action

Every

action

with

the

1 click

Button is send to the main

2 clicks

controller with Scene ID

3 clicks

equal to 1. Controller recog-

4 clicks

nizes type of action using the

attribute assigned to it.

5 clicks

hold

Release

Reset procedure of the Button:

Reset procedure allows to restore the device back to its factory set-

tings, which means all information about the Z-Wave controller and

user configuration will be deleted. In order to reset the device:

1. Click the Button exactly five times.

2. Press and hold the Button for at least 5 seconds.

NOTE

notifications

are

enabled, each press

of the button results

in sending a com-

mand

(notification

Type=hOME_SECuRI-

TY,

Event=Intrusion,

unknown Location).

Attribute

Key Pressed 1 time

Key Pressed 2 times

Key Pressed 3 times

Key Pressed 4 times

Key Pressed 5 times

Key held Down

Key Released

OPERATInG ThE DEvICE