Olympus BH2 Series Demontage, reiniging en hermontage - Pagina 20
Blader online of download pdf Demontage, reiniging en hermontage voor {categorie_naam} Olympus BH2 Series. Olympus BH2 Series 45 pagina's. Phase contrast
Ook voor Olympus BH2 Series: Handleiding voor probleemoplossing en afstelling (46 pagina's), Volledige demontage, reiniging en hermontage (23 pagina's), Volledige demontage, reiniging en hermontage (40 pagina's), Handmatig (6 pagina's), Installatiehandleiding (9 pagina's)
Using a cotton swab and a suitable solvent (acetone),
thoroughly clean the mating surface of the nosepiece
locking block, where it slides on the mount base (see
Figure
62).
Figure 62 – Clean the nosepiece locking block
Use a suitable solvent (acetone) to clean any grease or
contaminants from the threads of the nosepiece locking
thumbscrew (see
Figure
Figure 63 – Clean threads of the locking thumbscrew
Reassemble the New-Style Slide Mount (BHS/BHT)
Position the nosepiece locking block beneath the
nosepiece slide-mount base, making sure the bearing
surface of the locking block is in contact with the mount
base (see
Figure
64).
Figure 64 – Position locking block under slide-mount base
Teardown, Cleaning, and Reassembly of the Miscellaneous Parts of the Olympus BH-2 Microscope Frames
63).
Align the pivot-screw hole in the nosepiece slide-mount
base with the tapped hole in the nosepiece locking
block and use a suitable slotted screwdriver to reinstall
the pivot screw (see
Figure
Figure 65 – Reinstall the locking-block pivot screw
Align the stop-screw hole in the nosepiece slide-mount
base with the tapped hole in the nosepiece locking
block and use a suitable slotted screwdriver to reinstall
the stop screw (see
Figure
Figure 66 – Reinstall the locking-block stop screw
The newer style nosepiece slide mount is now ready to
be reinstalled into the stand and put back into service
(see
Figure
67).
Figure 67 – Slide-mount parts ready for use (new style)
65).
66).
Revision 1
Page 20 of 45