ESI ESPREE Montage- en bedieningshandleiding - Pagina 2

Blader online of download pdf Montage- en bedieningshandleiding voor {categorie_naam} ESI ESPREE. ESI ESPREE 8 pagina's. Pneumatic table base

ESPREE PNEUMATIC TABLE BASE

PLEASE REVIEW these instructions before beginning the assembly procedures. Check that all the parts shown

below were provided with your order. Contact your supplier if any materials are missing. Do not discard the

packaging until satisfied that the product operates to your satisfaction.

PARTS AND TOOLS PROVIDED

Frame Assembly (1)

Cable Clip (2)

ADDITIONAL TOOLS REQUIRED

• #2 and #3 Phillips screwdriver

• Power drill and

" drill bit

WARNING:

in the upright position. Do not remove any bolts or hardware from the leg columns. Do not

remove the safety pin, safety ring and warning tags until the table is fully assembled and

in the upright position. Sudden extension of the table legs may cause serious injury if these

instructions are not followed.

IMPORTANT: The columns of this table contain high force pneumatic springs that are sized to lift the work

surface and its contents. Proper sizing, handling, and assembly is critical to prevent damage to the columns

or serious injury. All persons not involved in the installation should remain at a safe distance until set-up is

complete and tested by a qualified installer.

Review the lift rating decal on the frame to learn the minimum and maximum lift weight for the unit. The lift

weight is the total weight of the work surface and the contents it supports.

Fasteners

M8x14 SHCS (8)

M8x15 SHCS (7)

CAUTION: Hand-tighten screws only. Do not use power tools.

Do not activate the release lever until the table is fully assembled and

Frame Support Brackets,

LH and RH (1 each)

Adjustable Feet (2)

M8x25 FHCS (1)

CAUTION: Always check that screws

used to attach components to the

work surface are not too long for the

thickness of the surface.

PARTS AND TOOLS

Allen Keys (1 each)

5mm

6mm

#12x1 PPH (8)

#8x¾ PPH (6)

Work

Surface