ESI ESPREE Montage- en bedieningshandleiding - Pagina 3

Blader online of download pdf Montage- en bedieningshandleiding voor {categorie_naam} ESI ESPREE. ESI ESPREE 8 pagina's. Pneumatic table base

Pagina afdrukken

ASSEMBLY

STEP 1

Lay the tabletop face down on a soft, clean

surface. Center the frame assembly with the release

cable facing the front.

STEP 2

Raise the top table leg to the vertical position.

• Align the holes on each side of the leg column

with the holes in the frame channel.

WARNING: Do not remove the safety pin

or the safety ring until the table is fully

assembled and in the upright position.

STEP 3

Attach a frame support bracket to the frame

channel and leg column. IMPORTANT: The long

side of the bracket must be toward the front of the

table, as shown.

• There are tapped holes in the leg column,

which are threaded for the M8x14 screws.

• The bottom of the support bracket fits under

the column and the holes on the bracket side

pieces align with the tapped holes.

• Use a 5mm Allen key to attach the support

bracket with four M8x14 screws, two on

each side. Do not tighten down the

screws yet.

STEP 4

Tighten the two pivot screws, one on each side.

• Use a 6mm Allen key.

STEP 5

Use the 5mm Allen key to tighten the four M8x14

screws to 7 ft.-lbs.

Leg

Column

Frame

Channel

M8x14

Frame

Support

M8x14

Pivot

Bracket

Screw

ESPREE PNEUMATIC TABLE BASE

Safety

Ring

Align

Holes

Release

Cable

Tapped

Holes

Pivot

Screw