Anchor VMS 25x32 Instrukcja montażu - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Namiot Anchor VMS 25x32. Anchor VMS 25x32 16 stron. Vehicle maintenance shelter 25' x 32' with extension kits

Drukuj stronę

STEP 3 - Add Upper Legs to one Side.

• Lay out the parts as shown. Three (3) upper legs and two (2) purlins.

• The upper leg has angled cuts on one end and square cut on the other.

• The angled/labeled end goes toward the eave weldments.

• Lift the top frame using the eave purlins and insert the upper leg onto the eave weldments. Secure with pin.

• Connect the upper legs together with 2 purlins. This is easiest if the purlin is pinned to the mid leg first before the end

leg is moved into alignment and pinned.

• Pin the four eave covers (2 per end) on each end as shown above.

STEP 4 - Add Upper Legs

to the other Side.

See

Figure 3.

• Assemble as the previous step.

STEP 5 - Add Lower Legs to

Side.

• Lay out the parts. Three (3) lower

legs, three (3) base plates and two

(2) purlins. See Figure 5a.

• The lower leg has a splice inserted

in the square cut end. The splice

goes toward the upper leg.

• The base plates should be

secured in the legs with the appro-

priate hardware. Bolt and eyenuts

on the end legs, eyebolt and eyenut

for the mid leg. See Figure 5b.

See Figure 3.

Eave

purlin

Upper

Leg, left

Splice

Eave end

weldment.

Eave Cover

Figure 3

Figure 5a