GREAT PLANES ElectriFly PEAK 400 Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Ładowarka GREAT PLANES ElectriFly PEAK 400. GREAT PLANES ElectriFly PEAK 400 13 stron.

b. The battery somehow has becomes disconnected from

the charger while it was in the charge process.

c. If the battery was accidentally connected to the output

connector in reverse polarity.

In any case, recheck to make sure the battery is connected to

the output connector properly as explained above. Check to

make sure the charge lead is making good contact with the

charger's output connector, and with the battery to be

charged, and that proper polarity is being observed.

The Peak 400 charger uses solid-state and fused

circuitries to protect against potential damage which could

be caused by short-circuit or reverse polarity conditions.

Reverse Input Polarity: If input power to the charger is

connected in reverse polarity, the charger will be protected from

damage by blowing the external 7.5A fuse, but will be protected

from damage. Re-check all input connections and the power

source to ensure the proper power and polarities are observed.

Battery Condition Pre-Check: Any time a command is given

to begin charging a battery, the charger will check the condition

of the battery and determine if it is suitable for charging. If an

error exists on the output, the LEDs will flash red and green

simultaneously to note the error.This can occur when a battery

is connected to the output in reverse polarity, or if the charger

does not recognize a solid electrical connection to the battery

on the output. The charger will be protected from damage in

either case. Make sure the battery is solidly connected to the

output in proper polarity.

TECTION FEA

TURES