GREAT PLANES ElectriFly PEAK 400 Instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Ładowarka GREAT PLANES ElectriFly PEAK 400. GREAT PLANES ElectriFly PEAK 400 13 stron.

Current Overload: if for some reason a short circuit condition

exists on the input or output, the 7.5A spade (auto) fuse

located on the left side of the charger might blow. In this case,

make sure the charger is disconnected from the power supply.

Remove and inspect the fuse. If the fuse is blow, replace with

another fuse of the exact same rating.

OUBLESHOO

TING GUIDE

OUBLESHOO

TING GUIDE

PROBLEM: Charger doesn't recognize battery.

CAUSES AND CURES: 1) Battery may be connected

backwards. Connect battery leads properly. 2) Defective

cell in the pack. Replace battery pack or cell.

PROBLEM: Does not automatically terminate trickle

charge of NiCd or NiMH batteries after 3 hours.

CAUSE AND CURE: Internal problem with charger.

Disconnect battery immediately and contact Hobby

Services for further details.

PROBLEM: Battery voltage low after charge (below 1.2V

per cell for NiCd and NiMH batteries,).

CAUSES AND CURES: 1) Charge rate setting too low. See

"Charging Batteries". 2) Battery connected in reverse.

Connect battery leads properly. 3) Defective battery needs

to be replaced.

PROBLEM: LEDs and controls do not function properly.

CAUSES AND CURES: Battery possibly connected

backwards. Connect battery leads properly, or contact

Hobby Services for further details.