Cisco 12016 Instrukcja wymiany - Strona 25

Przeglądaj online lub pobierz pdf Instrukcja wymiany dla Router sieciowy Cisco 12016. Cisco 12016 32 stron. Blower module and air filter for cisco 12016, cisco 12416, and cisco 12816 router
Również dla Cisco 12016: Instrukcja rozpakowywania Podręcznik (28 strony), Arkusz danych (9 strony), Instrukcja obsługi (16 strony), Instrukcja wymiany (18 strony)

Drukuj stronę

Set a blocking plate into the hold-down bracket so that the blank side of the blocking plate is against the

Step 8

heads of the bolts in the side of the scissor-jack platform and the open holes in the blocking plate align

with the bolt holes in the top of the pallet.

Insert bolts through each of the hold-down bracket holes and into the holes in the top of the shipping

Step 9

pallet, then use the 9/16-inch (14-mm) wrench to tighten the bolts.

Turn the scissor-jack screw slowly clockwise to collapse the scissor-jack platform and raise the base of

Step 10

the scissor-jack platform until the weight of the chassis and scissor-jack platform is absorbed by the

pallet. Continue turning the scissor-jack screw clockwise to close the scissor-jack platform and lift the

base of the scissor-jack platform until it is completely closed (the screw can not be turned).

Repackaging the Chassis for Shipment

To repackage the chassis, use

Verify that the anchor clips fastening the chassis to the scissor-jack platform are installed correctly and

Step 1

that the bolts are tight.

Verify that the bolts fastening the hold-down brackets to the sides of the scissor-jack platform and the

Step 2

top of the pallet are tight.

If required, place the accessories package against the back panel of the router on the extended deck of

Step 3

the pallet body.

To install the U-shaped, corrugated side panels, use

Step 4

Because the two U-shaped side panels are identical, interlocking them in this fashion maintains the

Note

correct overall container dimensions and strength.

To fasten the two U-shaped side panels together, use

Step 5

Set the corrugated top cap on top of the container side panels and push it down.

Step 6

78-16082-01

Figure 17

Set the long side of one panel on the pallet base such that it sits inside the bead-boards attached to

the outside corners of the pallet riser blocks and against the side of the pallet platform.

Set the narrow end flaps of the panel inside the bead-boards attached to the outside corners of the

pallet riser blocks.

Position the opposite U-shaped side panel such that one narrow end flap is inside the narrow end

flap of the first U-shaped side panel, while the other narrow end flap is outside the narrow end flap

of the first U-shaped side panel.

Starting at one of the top holes on one narrow side panel, align the holes in the inner and outer

corrugated panels.

Open a plastic locking clip by pulling the wedge block out of the clip.

Insert the clip into the hole, then pivot the wedge block into the opening on the body of the clip and

push firmly until it snaps into place, spreading the butterfly tabs and locking the inner and outer side

panels together.

Repeat Step

through Step

Repeat Step

through Step

Cisco 12016, Cisco 12416, and Cisco 12816 Router Chassis Replacement Instructions

as a reference and follow these steps:

Figure 17

for the remaining holes on the narrow side panel.

for the opposite narrow side panel.

Removing and Installing the Chassis

as a reference and follow these steps: