Sony 2005 SXRD KDS-R50XBR1 Instrukcja demontażu - Strona 16
Przeglądaj online lub pobierz pdf Instrukcja demontażu dla TV Sony 2005 SXRD KDS-R50XBR1. Sony 2005 SXRD KDS-R50XBR1 31 stron.
Drukuj stronęAccess & Removal of Q -Box & PD-Board (cont.)
PD-Board
Lift clamps
Disconnect
Gently flip
up Tan Tab
(Digital Module Block DMB )
Q-Box
Assembly
Screws
Tabs
Wire Protector
(under wires)
Heat-sink
Pads
Disconnect
LVDS
Disconnected
i-Link
14
6. Q-Box & PD-Board Removal
3
The Q-Box assembly and the
PD-Board (HDMI) can now be
access and removed.
To remove the PD-Board
remove 2 screws, squeeze the
2 white tabs, and disconnect the
2 wires.
Squeeze
side-tabs
LVDS
4
To remove the Q -Box module first
disconnect the CableCard ribbon
cable.
Remove 2 white cable clamps that
hold down the ribbon cable.
Disconnect the cable from the
CableCard board by lifting the Tan
connector tab.
CAUTION:
Make sure that the blue
heat-sink pads remain in place .
Also insure that black plastic wire
protector remains in place .
Disconnect the LVDS cable located
at the bottom of the Q -Box assembly
under the gray tape .
Disconnect the i-Link cable.