3D Systems CubePro Manual - Página 9

Procurar online ou descarregar pdf Manual para Impressoras 3D 3D Systems CubePro. 3D Systems CubePro 11 páginas. Unjamming extruder
Também para 3D Systems CubePro: Manual de instruções original (18 páginas), Manual de instruções original (12 páginas)

Imprimir página
3D Systems CubePro Manual
 Remove buckled filament from within the extruder drive using flat end pliers. Make sure there is no
filament left inside. Manually turn the drive wheel to make sure there is no filament left wound on
the wheel.
 Replace the idler wheel assembly, being careful not to damage the sensor disk or sensor sticker.
 Before replacing sensor PCB, if your sensor board is equipped with a filament sensor make sure the
filament sensor is properly installed and aligned in the connectors. Make sure the filament sensor
installed in the recess inside the block and PCB is flush with the stand­offs. If it is not the case, make
sure that everything is aligned properly. Use flat end pliers to hold the screws while fixing the PCB
to extruder drive.
Note: Not all sensor boards will have a filament sensor (circled above). Machines shipped from 3D Systems
after February 2016 do not require a filament sensor