- ページ 9

3Dプリンター 3D Systems CubeProのPDF マニュアルをオンラインで閲覧またはダウンロードできます。3D Systems CubePro 11 ページ。 Unjamming extruder
3D Systems CubePro にも： オリジナル取扱説明書 (18 ページ), オリジナル取扱説明書 (12 ページ)

ページを印刷する
3D Systems CubePro マニュアル
 Remove buckled filament from within the extruder drive using flat end pliers. Make sure there is no
filament left inside. Manually turn the drive wheel to make sure there is no filament left wound on
the wheel.
 Replace the idler wheel assembly, being careful not to damage the sensor disk or sensor sticker.
 Before replacing sensor PCB, if your sensor board is equipped with a filament sensor make sure the
filament sensor is properly installed and aligned in the connectors. Make sure the filament sensor
installed in the recess inside the block and PCB is flush with the stand­offs. If it is not the case, make
sure that everything is aligned properly. Use flat end pliers to hold the screws while fixing the PCB
to extruder drive.
Note: Not all sensor boards will have a filament sensor (circled above). Machines shipped from 3D Systems
after February 2016 do not require a filament sensor