3D Systems CubePro 매뉴얼 - 페이지 9

{카테고리_이름} 3D Systems CubePro에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems CubePro 11 페이지. Unjamming extruder
3D Systems CubePro에 대해서도 마찬가지입니다: 원본 사용 설명서 (18 페이지), 원본 사용 설명서 (12 페이지)

페이지 인쇄
3D Systems CubePro 매뉴얼
 Remove buckled filament from within the extruder drive using flat end pliers. Make sure there is no
filament left inside. Manually turn the drive wheel to make sure there is no filament left wound on
the wheel.
 Replace the idler wheel assembly, being careful not to damage the sensor disk or sensor sticker.
 Before replacing sensor PCB, if your sensor board is equipped with a filament sensor make sure the
filament sensor is properly installed and aligned in the connectors. Make sure the filament sensor
installed in the recess inside the block and PCB is flush with the stand­offs. If it is not the case, make
sure that everything is aligned properly. Use flat end pliers to hold the screws while fixing the PCB
to extruder drive.
Note: Not all sensor boards will have a filament sensor (circled above). Machines shipped from 3D Systems
after February 2016 do not require a filament sensor