3D Systems CubePro 매뉴얼 - 페이지 8

{카테고리_이름} 3D Systems CubePro에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems CubePro 11 페이지. Unjamming extruder
3D Systems CubePro에 대해서도 마찬가지입니다: 원본 사용 설명서 (18 페이지), 원본 사용 설명서 (12 페이지)

페이지 인쇄
3D Systems CubePro 매뉴얼
 Remove the jet from the extruder drive. There is a notch on the nozzle that needs to meet up with
the slot in the extruder. Spin the nozzle while pulling slightly until you feel it meet the opening. You
will feel some resistance; this is normal, as you will need to break the filament buckled in the
extruder. After removing, the jet will look like shown below:
 Using side cutters provided with the toolbox, cut the filament protruding from cooling tube of the
jet. Aim to cut it as deep inside the cooling tube as possible, as it will help to purge the filament
through the jet later on.