3D Systems CubePro Manuale - Pagina 8

Sfoglia online o scarica il pdf Manuale per Stampanti 3D 3D Systems CubePro. 3D Systems CubePro 11. Unjamming extruder
Anche per 3D Systems CubePro: Manuale di istruzioni originale (18 pagine), Manuale di istruzioni originale (12 pagine)

 Remove the jet from the extruder drive. There is a notch on the nozzle that needs to meet up with

the slot in the extruder. Spin the nozzle while pulling slightly until you feel it meet the opening. You

will feel some resistance; this is normal, as you will need to break the filament buckled in the

extruder. After removing, the jet will look like shown below:

 Using side cutters provided with the toolbox, cut the filament protruding from cooling tube of the

jet. Aim to cut it as deep inside the cooling tube as possible, as it will help to purge the filament

through the jet later on.