3D Systems CubePro Manuale - Pagina 10

Sfoglia online o scarica il pdf Manuale per Stampanti 3D 3D Systems CubePro. 3D Systems CubePro 11. Unjamming extruder
Anche per 3D Systems CubePro: Manuale di istruzioni originale (18 pagine), Manuale di istruzioni originale (12 pagine)

 Check jet's loom and position of thermocouple as shown:

 Install the jet back into the extruder drive. Level the jets and check the check Z gap as shown starting

on page 62 of the user guide. Disconnect head loom from the breakout board to avoid damaging the

components while levelling the jets. There will be a warning message on the screen. This can be

ignored for now. Replace the head loom connector when finished and reinstall the breakout board

using the two 2.5 mm Hex screws.

 Connect all looms back to sensor PCB and breakout board according to their markings.