3D Systems CubePro Podręcznik - Strona 10

Przeglądaj online lub pobierz pdf Podręcznik dla Drukarki 3D 3D Systems CubePro. 3D Systems CubePro 11 stron. Unjamming extruder
Również dla 3D Systems CubePro: Oryginalna instrukcja obsługi (18 strony), Oryginalna instrukcja obsługi (12 strony)

Drukuj stronę
3D Systems CubePro Podręcznik
 Check jet's loom and position of thermocouple as shown:
 Install the jet back into the extruder drive. Level the jets and check the check Z gap as shown starting
on page 62 of the user guide. Disconnect head loom from the breakout board to avoid damaging the
components while levelling the jets. There will be a warning message on the screen. This can be
ignored for now. Replace the head loom connector when finished and reinstall the breakout board
using the two 2.5 mm Hex screws.
 Connect all looms back to sensor PCB and breakout board according to their markings.