3D Systems CubePro Руководство - Страница 10

Просмотреть онлайн или скачать pdf Руководство для 3D-принтеры 3D Systems CubePro. 3D Systems CubePro 11 страниц. Unjamming extruder
Также для 3D Systems CubePro: Оригинальное руководство по эксплуатации (18 страниц), Оригинальное руководство по эксплуатации (12 страниц)

 Check jet's loom and position of thermocouple as shown:

 Install the jet back into the extruder drive. Level the jets and check the check Z gap as shown starting

on page 62 of the user guide. Disconnect head loom from the breakout board to avoid damaging the

components while levelling the jets. There will be a warning message on the screen. This can be

ignored for now. Replace the head loom connector when finished and reinstall the breakout board

using the two 2.5 mm Hex screws.

 Connect all looms back to sensor PCB and breakout board according to their markings.