3D Systems CubePro Посібник - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник для 3D-принтери 3D Systems CubePro. 3D Systems CubePro 11 сторінок. Unjamming extruder
Також для 3D Systems CubePro: Оригінальна інструкція з експлуатації (18 сторінок), Оригінальна інструкція з експлуатації (12 сторінок)

 Remove the jet from the extruder drive. There is a notch on the nozzle that needs to meet up with

the slot in the extruder. Spin the nozzle while pulling slightly until you feel it meet the opening. You

will feel some resistance; this is normal, as you will need to break the filament buckled in the

extruder. After removing, the jet will look like shown below:

 Using side cutters provided with the toolbox, cut the filament protruding from cooling tube of the

jet. Aim to cut it as deep inside the cooling tube as possible, as it will help to purge the filament

through the jet later on.