3D Systems CubePro Посібник - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник для 3D-принтери 3D Systems CubePro. 3D Systems CubePro 11 сторінок. Unjamming extruder
Також для 3D Systems CubePro: Оригінальна інструкція з експлуатації (18 сторінок), Оригінальна інструкція з експлуатації (12 сторінок)

 Remove buckled filament from within the extruder drive using flat end pliers. Make sure there is no

filament left inside. Manually turn the drive wheel to make sure there is no filament left wound on

the wheel.

 Replace the idler wheel assembly, being careful not to damage the sensor disk or sensor sticker.

 Before replacing sensor PCB, if your sensor board is equipped with a filament sensor make sure the

filament sensor is properly installed and aligned in the connectors. Make sure the filament sensor

installed in the recess inside the block and PCB is flush with the standoffs. If it is not the case, make

sure that everything is aligned properly. Use flat end pliers to hold the screws while fixing the PCB

to extruder drive.

Note: Not all sensor boards will have a filament sensor (circled above). Machines shipped from 3D Systems

after February 2016 do not require a filament sensor