DAIRY EQUIPMENT Dari-Kool Руководство по эксплуатации - Страница 6

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Морозильная камера DAIRY EQUIPMENT Dari-Kool. DAIRY EQUIPMENT Dari-Kool 14 страниц. Bulk milk cooler

Печатать страницу

will not operate when th pump and agitator do as they are

not wired together.

The condensing unit will onlv oper te

when the ice bank control is calling for ice building.

E. AGITATOR AND PUMP SWITCH-To turn the pump

and agitator off when there is no milk in the cooler an "0

OFF" toggle switch is located on the side of the cooler.

6. MOTORS

The conden8ing unit consists of a motor compressor and

fan motors. In addition to the above, each cooler is equipped

with a water pump which circulates the 33

ice water to

accomplish rapid cooling.

If a two-speed agitator is furnished

the two-speed switch should be set at "LO" for the cooling

operation. This insures proper cooling as it moves the milk

gently during the period of cooling. The milk hauler will place

the switch in "HI" position to insure a good composite sample.

7. OPERA ION

Befor putting milk in the cooler the first time, and each

time the cooler is empty thereafter, wash thoroughly.

Any

cleaner on the recommended list may be used. Be sure and

follow the directions on the package for proper solution.

We recommend that a plastic pail be used as you can set

this in the cooler with no danger of scratching the stain

less steel finish.

With the nylon brush furnished with each

tank, scrub all parts of tank making certain to clean the covers

and under the deck.

Open valve and let the tank drain.

Next, rinse tank with clear water.

The lids and measuring

stic can be placed in wash sink for cleaning. The milk valve

should be removed for cleaning.

(See special section on care

of valve). Just prior to pouring the first milk into the cooler

it is necessary to sterilize it.

Use a disinfectant recommended by your fieldman, in

the proper s lution recommended by the manufacturer. The

ea.c::iest and most economical method to sterilize a tank is

by the use of a sanitizer which your dealer can furnish you.

Drain any residue of the solution to prevent contamination

of milk.

Put the valve on cooler outlet making sure the Neoprene

Gasket is placed between the outlet and valve.

Close the

valve and your cooler is ready to receive milk.

We recommend starting the water pump 10 or 15 min

utes prior to adding milk to the tank, by setting the timer

to 30 minutes.

This will cool the tank down so when the

first milk is added you will have faster cooling. If you have

the agitator switch in the "OFF" position, be sure and turn

it on when milk is up part way on the blade.

The same

procedure should be followed on subsequent milkings.

- 4