Consolidated VYNIL-VAC ASP-1105 Руководство - Страница 4

Просмотреть онлайн или скачать pdf Руководство для Водяной насос Consolidated VYNIL-VAC ASP-1105. Consolidated VYNIL-VAC ASP-1105 6 страниц.

Operation- Liner Installation

OPERATION

LINER INSTALLATION PROCEDURES

When using your Vinyl-Vac System on a new construction installation where there is no existing deck to place it close to the pool, we suggest

you go to any building supplier and buy a piece of 4" weeping tile, non perforated, 2-3 feet or whatever length you need to position your

Vinyl-Vac System away from the pool. Connect the other end to the Vinyl-Vac inlet.

We suggest 4" weeping tile because the ribs are shallow and rounded. After testing, doesn't restrict air flow, also its flexibility does not break

down after extended use and it's inexpensive.

We do not supply the weeping tile because it is too costly to package and ship and we would have to pass this expense on to you, the dealer.

"What if I have sand bottoms?"

When installing a liner in a pool with a sand bottom, keep the 4" pipe 1" from the sand bottom and drill four 9/16" holes in the side of the pipe,

2 holes on each side, not more than 6" from the bottom. This relieves the concentration of suction from the bottom of the pipe. The reason for

keeping the 9/16" holes low on the pipe is to keep the suction low on the pipe where the cove is at the bottom of the wall. The cove is the air

channel around the pool.

"What if I have foamed walls, how do I keep the foam from being sucked into

the pipe"

After positioning the Vinyl-Vac System cut a 6"-7" arch in the foam at the point of entry

for the pipe, as shown in Fig.6, before installing the liner.

After you're finished installing the sand bottom liner we suggest you tape the 9/16"

holes with duct tape to return full suction concentration to the bottom of the pipe so if

your next liner installation has ground water it will be able to pick it up.

FIGURE 6