Canon PIXMA MX850 Ağ Kurulum Kılavuzu - Sayfa 37
Hepsi Bir Arada Yazıcı Canon PIXMA MX850 için çevrimiçi göz atın veya pdf Ağ Kurulum Kılavuzu indirin. Canon PIXMA MX850 43 sayfaları. Multifunction brochure
Ayrıca Canon PIXMA MX850 için: Tamamlayıcı Kılavuz (6 sayfalar), Kurulum Talimatları (2 sayfalar), Broşür (2 sayfalar)
Sayfayı Yazdır
- 1. Setup Outline
- 2. Setting up the Machine and the Computer (Windows)
- 3. Preparing for Setup
- 4. Installing the Software
- 5. Setting up for Use over Wired Lan
- 6. Setting up the Machine and the Computer (Macintosh)
- 7. Cannot Connect to the Machine (the Machine Is Not Detected)
- 8. Setting up the Machine Again for Use over Network
"Communication with the Card Slot failed." is displayed
Cause
The network setup of the Card Slot
fails.
Wait for a while, then click Retry.
(1)Retry
Click to retry the network setup of the Card Slot.
(2)Skip
Click to continue installation without the network setup of the Card Slot.
If it fails again after clicking Retry, follow the procedure below.
Make sure that the computer is communicating with the network properly,
then try again.
Disable the Windows Firewall function, or open port 137:139 to allow
communication with the machine following the procedure below. For
information on other security software, refer to its instruction manual or
contact its manufacturer.
Important
If you disabled the firewall function, disconnect your network from the
Internet. To do this, configure your router not to connect to the Internet or
WAN.
To disable the Windows Firewall:
(1)Click Start > Control Panel > Security Center > Windows Firewall.
(2)Select Off, and click OK.
To open port 137:139:
(1)Click Start > Control Panel > Security Center > Windows Firewall.
(2)Select the Exceptions tab, and click Add port.
(3)On the Add a Port dialog box, input the following information, and click
OK.
Name: Input any name for the port.
Port number: Input "137".
TCP/UDP: Select TCP.
(4)Repeat steps (2) and (3). On the Add a Port dialog box, input the same
information as you did in step (3) except for selecting UDP in TCP/UDP.
(5)Use the same procedure to open the other ports (138TCP, 138UDP,
139TCP, and 139UDP).
(6)Confirm that the port names are added on the Exceptions sheet, and
click OK.
Action
(1)
(2)
Troubleshooting
35