Draper Premier Talimatlar Kurulum ve Çalıştırma

Projeksiyon Perdesi Draper Premier için çevrimiçi göz atın veya pdf Talimatlar Kurulum ve Çalıştırma indirin. Draper Premier 7 sayfaları. 220v premier electric projection screen
Ayrıca Draper Premier için: Kurulum ve Kullanım Talimatları (2 sayfalar), Kurulum ve Kullanım Talimatları (2 sayfalar), Kurulum Talimatları (2 sayfalar), Kurulum Talimatları (4 sayfalar), Kurulum Talimatları (2 sayfalar), Kurulum Talimatları (2 sayfalar), Kurulum ve Kullanım Talimatları (4 sayfalar), Kurulum ve Kullanım Talimatları Kılavuzu (7 sayfalar)

Sayfayı Yazdır

Premier

Electrically operated projection screen with motor-in-roller

Overview - Components

Junction Box

Section 1 - Removing Shipping Brackets

CAUTION: Shipping support brackets must be removed from bracket

clamps at each end of dowel before initial operation, and before

screen is operated in UP direction.

CAUTION: Raise and lower viewing surface several times to confirm

satisfactory operation. If viewing surface does not operate properly,

turn power off and check electrical connections.

Read and understand all warnings

Contents

Overview - Components ...............................................................................................1

Section 1 - Removing Shipping Brackets

Section 2 - Electrical Connections .............................................................................2

Section 3 - Operation....................................................................................................2

PLEASE READ - Safety Information ............................................................................2

Section 4 - Hanging Screen and Methods of Installation .......................................3

Cable

Exit

(without cover)

Tension

Cable

(Figure 1)

..................................................1

(Figure 1)

Dowel

1. Remove

1. Remove fasteners

fasteners

from bracket clamps.

from

bracket clamps.

4. Retighten dowel

endcap screws.

CAUTION

before beginning installation.

(Page 2 of this document)

Section 5 - Limit Adjustments .....................................................................................4

Section 6 - Tab-Tension Adjustment Procedure ......................................................4

Section 7 - Accessing Internal Low-Voltage Control Unit

Section 8 - Dimensions ................................................................................................5

Section 9 - Wiring Diagrams: Standard and Quiet Motor .......................................6

Section 10 - Wiring Diagrams: Motor with internal low-voltage controller .........7

INSTRUCTIONS

INSTALLATION & OPERATION

Figure 1

2. Run the screen

DOWN to expose

dowel screws.

3. Loosen screws

and remove

shipping bracket.

.........................5

(LVC-IV)

If you have any difficulties installing or servicing your

Premier projection screen, call your dealer or Draper, Inc.

Draper, Inc. | 411 S. Pearl St. Spiceland, IN 47385

draperinc.com | 765.987.7999 | 800.238.7999

FORM: Premier_Inst20

TOOLS

REQUIRED

PENCIL

POWER DRILL

TAPE MEASURE

LEVEL

HARDWARE

(by others)