Anderson ANM75 Kullanım Kılavuzu - Sayfa 8

Brülör Anderson ANM75 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Anderson ANM75 18 sayfaları.

– Fuel type and fuel supply pressure

– Adequate fresh, clean, combustion air

– Humidity, altitude, temperature and presence of damaging corrosive gases of the

supply air.

10.5 Burner Mounting

1. Mounting methods

The installation modes of ANM75 series burners are as follows: process air parallel

to combustion flame, process air vertical to combustion flame, the former can be

divided into blower installed in the air duct and outside the air duct, the specific

diagram shows as fig 6 that the air duct burner installed in the center of the air duct.

2. Corner distance

When laying in the duct, allow least length downstream of the burner should be

1100mm to avoid flame impingement; as fig 7 below shown, please see fig 5 for

flame length.

When burner longer than 900 mm, use a hanger or a pedestal to support the blower

and motor. Process air velocity must be within the limits.

Anderson Thermal Soluions（Suzhou）Co. ,Ltd.

Anderson Thermal Solutions – ANM75 Burner Operation Manual

Fig 6. ANM 75Series Burner Installation Layout

Fig 7. ANM75 Series Burner Installation Layout