2gig Technologies Vario Hızlı Kurulum Kılavuzu - Sayfa 7

Güvenlik Sistemi 2gig Technologies Vario için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. 2gig Technologies Vario 18 sayfaları. Voice module
Ayrıca 2gig Technologies Vario için: Kurulum Talimatları Kılavuzu (6 sayfalar), Hızlı Kullanım Kılavuzu (10 sayfalar)

Sayfayı Yazdır

2gig Technologies Vario Hızlı Kurulum Kılavuzu

2GIG Vario Quick Install Guide

Maximum Current Flows

3. Wire Auxiliary Devices

Use the Auxiliary Power AUX (+) COM (–) terminals to power PIRs, glass-break detectors (4-wire types), smoke detectors, audio switches,

photoelectric systems and/or any device that requires a 12VDC power supply.

4. Wire the Internal Bell

The Bell/LS terminal provides power to the internal siren. When connecting an internal sounding device, pay attention to the polarity.

It is important to position the BELL/LS DIP switch SW1 correctly. The position varies depending on the type of internal siren.

To avoid bell loop trouble, if no connections are made to an internal siren, use a 2.2KΩ resistor in its place.

5. Wire the Bell Tamper

Connect the bell tamper to the BELL TMP and COM terminals on the main panel using 2.2KΩ resistors.

IMPORTANT:

If you DO NOT use the terminal TMP BELL, remember to connect a 2.2KΩ resistor (resistor colors: red, red, red) between

the TMP and COM.

6. Wire Utility Output 1 to Activate Self-Powered Devices

Utility output 1 can be used to activate a self-powered siren or any other self-powered device.