2gig Technologies Vario Посібник зі швидкого встановлення - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник зі швидкого встановлення для Система безпеки 2gig Technologies Vario. 2gig Technologies Vario 18 сторінок. Voice module
Також для 2gig Technologies Vario: Інструкція з монтажу Посібник з монтажу (6 сторінок), Короткий посібник користувача (10 сторінок)

2GIG Vario Quick Install Guide

Maximum Current Flows

3. Wire Auxiliary Devices

Use the Auxiliary Power AUX (+) COM (–) terminals to power PIRs, glass-break detectors (4-wire types), smoke detectors, audio switches,

photoelectric systems and/or any device that requires a 12VDC power supply.

4. Wire the Internal Bell

The Bell/LS terminal provides power to the internal siren. When connecting an internal sounding device, pay attention to the polarity.

It is important to position the BELL/LS DIP switch SW1 correctly. The position varies depending on the type of internal siren.

To avoid bell loop trouble, if no connections are made to an internal siren, use a 2.2KΩ resistor in its place.

5. Wire the Bell Tamper

Connect the bell tamper to the BELL TMP and COM terminals on the main panel using 2.2KΩ resistors.

IMPORTANT:

If you DO NOT use the terminal TMP BELL, remember to connect a 2.2KΩ resistor (resistor colors: red, red, red) between

the TMP and COM.

6. Wire Utility Output 1 to Activate Self-Powered Devices

Utility output 1 can be used to activate a self-powered siren or any other self-powered device.