CORNING FTH-76 Series Hızlı Başlangıç Kılavuzu - Sayfa 4

Muhafaza CORNING FTH-76 Series için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. CORNING FTH-76 Series 4 sayfaları. Fiber transition housing

Sayfayı Yazdır

FEEDER CABLE INSTALLATION

Step 1:

Remove cable sheath and strength members per standard company practices.

Step 2:

Pierce grommet and insert feeder cable into the unit. Remove strain-relief hardware

using a can wrench. Strain-relieve the cable with the clamp as shown in Figure 3.

Step 3:

Route slack around the perimeter of the unit, securing to the lances with cable ties as

needed.

Step 4:

Remove dust caps from adapter and connector. Clean per standard company

practices. Mate connector into adapter as shown.

DROP CABLE INSTALLATION

Direct

Connectorization

TPA-3692

Step 1:

Pierce grommet and insert cable into the unit. Remove strain-relief hardware with a

can wrench. Strain-relieve with the clamp as shown in Figure 3.

Step 2:

If splicing is required, splice to pigtails per the instructions provided with the splicing

equipment. Store fiber in the splice organizer and fiber management spool

(Figure 4).

Step 3:

Route slack around the perimeter of the unit, securing to the lances with cable ties as

needed.

Step 4:

Remove dust caps from adapter and connector. Clean per standard company

practices. Mate connector into adapter as shown.

SECURE THE UNIT

Step 1:

Snap the outer cover closed. Secure with a can wrench.

Step 2:

If desired, install a padlock or security seal through the padlock hole.

Corning Optical Communications LLC • PO Box 489 • Hickory, NC 28603-0489 USA

800-743-2675 • FAX: 828-325-5060 • International: +1-828-901-5000 • www.corning.com/opcomm

Corning Optical Communications reserves the right to improve, enhance, and modify the features and specifications of Corning Optical Communications products

without prior notification. A complete listing of the trademarks of Corning Optical Communications is available at www.corning.com/opcomm/trademarks. All other

STANDARD RECOMMENDED PROCEDURE 205-451 | ISSUE 3 | MAy 2019 | PAGE 4 OF 4

Fiber Management Spool and Splice Organizer

Fiber Manage-

ment Spool

Figure 4 — Install Drop Cable