Jandy Jandy Pro Series Kullanıcı El Kitabı - Sayfa 7

Yüzme Havuzu Filtresi Jandy Jandy Pro Series için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Jandy Jandy Pro Series 20 sayfaları. Single element cartridge pool & spa cs filters
Ayrıca Jandy Jandy Pro Series için: Kullanıcı El Kitabı (12 sayfalar), Kurulum Kılavuzu (16 sayfalar), Kurulum ve Kullanım Kılavuzu (20 sayfalar), Manuel (8 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar), Kurulum ve Kullanım Kılavuzu (20 sayfalar), Kurulum Talimatları (2 sayfalar), Kurulum ve Kullanım Kılavuzu (16 sayfalar), Kurulum ve Kullanım Kılavuzu (16 sayfalar), Kurulum ve Kullanım Kılavuzu (16 sayfalar)

Nicheless Underwater LED Lights | Owner's Manual

3.2

Installing the Light Fixture

NOTE: Perform these steps only after the electrical system requirements

are met.

Keep protective cover on to protect the light during installation.

NOTE: Gasket helps ensure

that the conduit is not a

potential leak path

Figure 2.

Standard installation with 1.5" pool wall fitting

Snake the electric cord through the conduit outlet of the wall fi tting,

into the conduit and up to the location of the pool transformer. Cut the

cord 18"-24" beyond the length needed to reach the transformer to

allow for a service loop. Pull the fi xture snug to the wall fi tting.

Remove protective cover once light has been pulled into the fi tting.

Install cosmetic cover if desired.

NOTE: When using a 1 1/2" MIP fi tting on the back of a SP-1022 or

SP-1408 Wall Fitting, the interior of the Spears and Dura MIP are too

small for use with the Jandy

Using the included installation tool, thread

the light into the wall fi tting until it is snug.

The light face must be completely ﬂ ush

with the return fi tting. Please provide the

pool owner with a minimum of 1 key upon

job completion.

See Table 1

for min. length

requirements

Pro Series Nicheless LED Lights.

ENGLISH

The light face must be completely

snug with the return fitting without

any protrusion from the light fixture.

Page 7