Panasonic WVNF302 - NETWORK CAMERA Kurulum Kılavuzu - Sayfa 22

Video Kamera Panasonic WVNF302 - NETWORK CAMERA için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Panasonic WVNF302 - NETWORK CAMERA 36 sayfaları. Ip video cameras
Ayrıca Panasonic WVNF302 - NETWORK CAMERA için: Broşür (2 sayfalar), Kullanım Talimatları Kılavuzu (20 sayfalar), Referans (2 sayfalar), Karşılaştırma Tablosu (6 sayfalar), Entegrasyon Notu (8 sayfalar), Kullanım Talimatları Kılavuzu (20 sayfalar)

Connections

Step 1

Connect the monitor cable between the mon-

itor out connector inside the dome cover and

the video in connector of the video monitor

(only when adjusting angular field of view).

Monitor out connector (for adjustment)

Important:

The monitor out connector is provided

only for checking the adjustment of the

angular field of view on the video monitor

when installing the camera or when serv-

icing.

It is not provided for recording/ monitor-

ing use.

Step 2

Connect a power cord from a power supply.

12 V DC power terminal

• When using 12 V DC power supply

q Remove 3 mm – 7 mm {1/8" – 5/32"} of

the outer jacket of the power cord from a

12 V DC power supply and twist the core

of the power cord to prevent a short cir-

cuit.

Approx. 3 mm - 7 mm {1/8" - 5/32"}

Specification of cable (wire):

AWG #16 - #28 Single core, twisted

w Loosen the screws of the provided power

cord plug and insert the power cords into

the power cord plug until the exposed

core wires are completely hidden.

e Tighten the screws to fix the inserted

power cords.

* Make sure that the exposed core wires

are completely hidden after tightening

the screws.

Power cord plug

(provided as a

standard accessory)

r Insert the power cord plug to the power

cord terminals on the mounting side of

the camera.

* Make sure that the power cord plug is

inserted to the power cord terminal firm-

ly.