Xerox WorkCentre M24 Color Hızlı Bağlantı Kılavuzu

Yazıcı Xerox WorkCentre M24 Color için çevrimiçi göz atın veya pdf Hızlı Bağlantı Kılavuzu indirin. Xerox WorkCentre M24 Color 4 sayfaları. Creating mailbox
Ayrıca Xerox WorkCentre M24 Color için: Hızlı Başlangıç Kılavuzu (4 sayfalar), Broşür ve Teknik Özellikler (4 sayfalar), Hızlı Başlangıç Kılavuzu (4 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar), Hızlı Başlangıç Kılavuzu (4 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar)

Purpose: Refer to this guide to modify the printer network settings at the printer user interface screen if required. For complete instructions

refer to the Customer Documentation CD.

Note: A Network Administrator is required to ensure that the printer is configured properly.

To properly configure the printer, the Network Administrator must supply an IP Address, a Subnet Mask, and a Gateway Address if applicable.

For information to configure the printer on a Novell network refer to the System Administration Guide in the Customer Documentation CD.

Procedure: The WorkCentre M24 has been designed to connect to most networks with minimal changes. Connect the printer to the network

and review the Default Printer Settings. Continue with Steps 2-6 and make changes to the printer port / network settings if required to enable it

on your

network.

Default Port Settings

Parallel—Enabled

LPD—Enabled

Netware—Disabled

SMB—Enabled

IPP—Enabled

Ethertalk—Enabled

Salutation—Enabled

Port 9100—Enabled

SNMP—Enabled

FTP Client—Enabled

Internet Service—Enabled

quire, continue on Step 3.

Press "Access" button on the User Interface Control Panel.

Enter "System Administrator" Password. (Default – 11111)

Press "Confirm"

Press "System Settings"

Press "Network Settings"

Select "Port Settings"

Select desired Port.

Select "Change Settings"

10. Follow Screen instructions to modify the port setting.

11. Select "Close" to return to the "Network Settings" screen and continue with item 7 in Step 3 "Protocol Setup".

12. If no further changes are required, continue to select "Close" to exit the System Setup.

13. Continue on Step 4.

- These are the Default Printer Settings

Default Network Settings

IP Address: Get IP Address (DHCP)

Printer Name: FX-0D9496

Workgroup: "WORKGROUP"

Print Queue: fx-0d9496

Port Setup

Follow this procedure if you want to make any changes to the Port Settings.

If no changes are re-