Fujitsu SPARC Enterprise M5000 Посібник з експлуатації - Сторінка 21

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Сервер Fujitsu SPARC Enterprise M5000. Fujitsu SPARC Enterprise M5000 30 сторінок. Rci build procedure
Також для Fujitsu SPARC Enterprise M5000: Додатковий посібник (36 сторінок), Примітки до продукту (44 сторінок), Посібник для початківців (4 сторінок)

3. Verify that the key was added to the COD database:

XSCF> addcodactivation -r

The key you add should be listed in the output. See

Status" on page

4. Save the key in a safe place where you can refer to it if the XCP configuration

is reset, the COD database is lost, or some other event requires you to reinstall

it.

Note – Do not attempt to install the same COD key more than once, except as noted

Step

4. Doing so would be a contract violation.

▼ To Delete a COD Key

Before deleting a key from the COD database, the XSCF firmware determines

whether a sufficient number of active COD CPUs are available, plus headroom. If all

activated COD CPUs are in use and no headroom is available, the operation fails.

You can force the operation by using the -f option in

will overcommit any COD CPU reservations that might be in effect.

1. Log in to the XSCF console with platadm privileges.

2. Verify that you have enough COD permits or headroom to cover COD resources

currently in use.

Use the showcodactivation command as described in

Status" on page

compensate, power off one or more domains or disconnect the appropriate

number of boards.

3. Delete the key from the COD database:

XSCF> deletecodactivation key

4. Verify that the key was removed from the COD database:

XSCF> deletecodactivation -r

The key that you deleted should not be listed in the output. See

Permit Status" on page

13.

13. If you do not have sufficient COD permits or headroom to

13.

"To Display COD Permit

Step

3, below, but doing so

"To Display COD Permit

Capacity on Demand (COD) Administration

"To Display COD