CREE LIGHTING KBL EB WIRELESS Інструкція з монтажу Посібник з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Ліхтар CREE LIGHTING KBL EB WIRELESS. CREE LIGHTING KBL EB WIRELESS 9 сторінок. Wireless highbay led luminaire with emergency driver, universal hook and cord or pendant mount with sensor

Друкувати сторінку

TO INSTALL:

Luminaire Hook

Retainer Spring

Hook Adjustment

Screws

1/2" (13mm) IP,

0.875" (22mm)

O.D. Knockout

Pendant Adjustment

Pendant Slider

Plate

3/4" (19mm) IP,

1.125" (29mm)

O.D. Knockouts

"L" Channel

Hinged

Splice Box

2 of 8

Pendant Mount Hole

3/4" (19mm) IP, 1.125"

(29mm) O.D.

Hinged Splice

Box

1/2" (13mm) IP,

0.875" (22mm)

O.D. Knockouts

Hinged Splice Box

Screw

HOOK AND CORD MOUNT

STEP 1:

Push down on retainer spring until top of spring is free of

luminaire hook. See Figure 1.

STEP 2:

Slide hook into securely mounted customer supplied eye

hanger and return retainer spring to original position.

NOTE: The luminaire should already be factory set for

correct balance. If necessary, the fixture may be balanced

by loosening the hook adjustment screws on the top of

the housing and sliding the hook as necessary for correct

balance. Tighten hook adjustment screws when finished.

See Figure 1.

STEP 3:

Remove hinged splice box from top of housing by

loosening screw and sliding box to the right and up from

"L" channel. See Figure 2.

STEP 4:

Make wire connections per Electrical Connections found

on the last page, and then push the leads into hinged

splice box. Replace the plate and screw. Close the hinged

splice box and re-tighten the screw. See Figure 3.

PENDANT MOUNT

STEP 1:

Remove hinged splice box from top of housing by

loosening screw and sliding box to the right and up from

"L" channel. Unhook from hinge holes. See Figure 2.

STEP 2:

Remove hook, slider plate and cord and discard. Plug

junction box knockout hole with provided junction box

plug.

STEP 3:

Attach the supplied pendant mount slider plate using

(2) supplied screws. Use 3/4" threaded pendant, along

with two customer supplied locknuts (one for inside the

hinged splice box and one for outside the splice box).

Pull supply leads into position from customer supplied

conduit.

Note: If necessary, the luminaire may be balanced by

loosening (2) screws for pendant adjustment on the top of

the hinged splice box and sliding the adjustment plate as

necessary for correct balance. Tighten (2) screws when

finished. See Figure 2.

STEP 4:

Attach one end of the hinged splice box to luminaire by

aligning hinge slots on Mounting Bracket with hinges (on

splice box), and then inserting the hinges into the slots.

STEP 5:

Make wire connections per Electrical Connections and

then push the leads into hinged splice box. Replace the

plate and screw. Close the hinged splice box and re-

tighten the screw. See Figure 3.

STEP 6:

Secure other end of the hinged splice box to luminaire

by sliding screw on Mounting Bracket up and over in "L"

channel on the hinged splice box. See Figure 2.

STEP 7:

Secure luminaire to hinged splice box by tightening

screw.

LPN00814X0001A0_D