CREE LIGHTING KBL EB WIRELESS Інструкція з монтажу Посібник з монтажу - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Ліхтар CREE LIGHTING KBL EB WIRELESS. CREE LIGHTING KBL EB WIRELESS 9 сторінок. Wireless highbay led luminaire with emergency driver, universal hook and cord or pendant mount with sensor

Друкувати сторінку

Heatsink

4 of 8

Site Map Label

Safety Cable

SITE MAP LABEL

STEP 1:

Remove unit site map label Snap address. See

Figure 8.

STEP 2:

Apply site map label to the correct position on the site

map. See Figure 8.

INSTALLING SAFETY CABLE

NOTE: Safety Cable is sold separately as an

accessory, please refer to installation sheet in safety

cable packaging for complete installing instructions.

STEP 1:

Attach one end of the safety cable through the fin of

the heatsink. See Figure 9.

STEP 2:

Attach other end of the safety cable to mounting

surfaces using customer supplied hardware.

SYSTEM COMMISSIONING AND CUSTOMIZING

System commissioning is required for the fixtures to

be recognized on the Simply SNAP network. Contact

Cree Lighting at 800-236-6800 for more details about

commissioning and customization.

EMERGENCY DRIVER CHECK

NOTE: For short-term testing of the emergency

function, the battery must be charged for at least one

hour. The emergency driver must be charged for at

least 24 hours before conducting a long-term test.

STEP 1:

When AC power is applied, the charging indicator

light is illuminated, indicating the battery is being

charged. When power fails, the emergency driver

automatically switches to emergency power,

operating the LED array. When AC power is restored,

the emergency driver returns to the charging mode.

STEP 2:

Although no routine maintenance is required to keep

the emergency driver functional, it should be checked

periodically to ensure that it is working. The following

schedule is recommended:

• Visually inspect the charging indicator light

monthly. It should be illuminated.

• Test the emergency operation of the fixture at

30-day intervals for a minimum of 30 seconds.

When the test switch is depressed, the LED

array should operate.

• Conduct a 90-minute discharge test once a

year. The LED array should operate for at least

90 minutes.

If the luminaire fails any of these checks, consult

service personnel.

REFER ANY SERVICING INDICATED BY THESE

CHECKS TO QUALIFIED PERSONNEL

EMERGENCY DRIVER AND AC DRIVER MUST BE

FED FROM THE SAME BRANCH CIRCUIT.

LPN00814X0001A0_D