CREE LIGHTING KBL EB WIRELESS Інструкція з монтажу Посібник з монтажу - Сторінка 3

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Ліхтар CREE LIGHTING KBL EB WIRELESS. CREE LIGHTING KBL EB WIRELESS 9 сторінок. Wireless highbay led luminaire with emergency driver, universal hook and cord or pendant mount with sensor

Друкувати сторінку

Loosen

Screws

Reflector

Screw

3 of 8

Add 2 Screws For

Aluminum Reflectors

(4) Keyhole

Slots

Locking

Feature

Hinge Retainer

Frame Hinge

Mounting Ring

Reflector

Lens with V-band

REFLECTOR INSTALLATION

TOOL LESS REFLECTOR:

STEP 1:

Place the reflector over the luminaire mounting

tabs so that the big reflector keyhole slots align

with the tabs. See Figure 4.

NOTE: For aluminum reflectors, insert two screws,

provided with the reflector, for retention as shown

(4)

in Figure 4.

Luminaire

Mounting

STEP 2:

Tabs

Turn the reflector counter-clockwise until it locks

into place with the locking feature. See Figure 4.

STEP 3:

To remove the reflector, depress locking tab and

turn reflector clockwise.

STANDARD REFLECTOR:

STEP 1:

Loosen the (4) screws, shown in Figure 5, at least

0.1 inch from the heatsink.

NOTE: The view in Figure 5 is of the underside of

the luminaire.

STEP 2:

Bring trim into housing and line up the (4) screws

from Step 1, with the keyhole slots on the reflector.

STEP 3:

Rotate trim, turn clockwise and tighten the (4)

screws from Step 1.

Mounting Lens or Wire Guard To Aluminum

Reflector

STEP 1:

Secure the hinge retainer and frame hinge to the

reflector using supplied screw and lock nut. See

Figure 6.

NOTE: Reflector is pre-punched at position of this

installation.

STEP 2:

Swing the wire guard into place and secure to the

reflector with the attached spring latch. See Figure

Mounting Lens or Wire Guard To Prismatic

Reflector

STEP 1:

Place lens or wire guard onto the bottom of

reflector, and place V-band around lens and

reflector. See Figure 7.

STEP 2:

Secure lens or wire guard to reflector by tightening

screw on V-band. See Figure 7.

LPN00814X0001A0_D