Fujitsu FI-5530C2 Manual de introducción - Página 8

Navegue en línea o descargue pdf Manual de introducción para Escáner Fujitsu FI-5530C2. Fujitsu FI-5530C2 11 páginas. Image scanner
También para Fujitsu FI-5530C2: Primeros pasos (28 páginas), Manual de procedimientos de instalación (6 páginas), Especificaciones (2 páginas), Manual de introducción (27 páginas), Instrucciones de limpieza (2 páginas), Instrucciones de limpieza (2 páginas), Primeros pasos (11 páginas)

Imprimir página

Fujitsu FI-5530C2 Manual de introducción

Installation (Custom)

1. Perform steps 1. to 3. in

mended)" (page.

2. Click the [Installation (Custom)] button.

3. Select the check box for the software to install

and click the [Next] button.

4. Follow the instructions on the screen to pro-

ceed with the installation.

"Installation (Recom-

7).

2.4 Checking Scanner Driver

Operation

This section explains how to check the operation of the

installed scanner driver by using ScandAll PRO.

For details about scanning documents by using Paper-

Stream Capture and the PaperStream IP driver, refer to

the help of each software.

Make sure that the scanner driver is installed properly,

following the procedure below.

■ Checking the Operation of the

Scanner Driver

1. Load the document on the scanner.

For information about how to load the document,

refer to section 1.2 in fi-5530C2 Operator's

Guide.

2. Launch ScandAll PRO.

From the [start] menu, select [All Programs] ->

[Fujitsu ScandAll PRO] -> [ScandAll PRO].

⇒

ScandAll PRO starts up.

3. In ScandAll PRO, select [Tool] on the menu,

and then select [Preferences].

⇒

The [Setup] dialog box appears.

4. On the [Scan] tab, select a driver.

To check the operation of TWAIN, select

[TWAIN].

To check the operation of ISIS, select [ISIS].

5. Click the [OK] button to close the [Setup] dialog

box.

6. In ScandAll PRO, select [Scan] on the menu,

and then select [Select Scanner].

7. Select a scanner in the displayed dialog box.

To use TWAIN:

Select [FUJITSU fi-5530C2dj], and then click the

[Select] button.

To use ISIS:

Select [Fujitsu fi-5530C2] and then click the

[Select] button.

8. Select [Scan] on the menu, and then select

[Scan Settings].